1
clrmame Discussion / MESS XML import
« on: 02 September 2010, 20:37 »
Hello Roman,
It seems that the suggested method to load a MESS XML file doesn't work anymore. As soon as the changes are done to engine.cfg and clrmamepro is started again, clrmamepro will display an error while scanning the available datfiles.
The errormessage states "Found an incomplete datfile or a bad exe-output!" followed by information about the last set that is correctly imported.
At this point there has not been any datfile added and all sets were correct before the change.
Some more information that may be relevant:
- All datfiles in the profiler were either MESS softwarelists (XML) or MAME (XML).
- I'm running clrmamepro on Linux (64-bit) using Wine.
- I remember using this method successfully before with an older version of clrmamepro (I think until around version 3.134).
If you need more information let me know.
Thanks!
It seems that the suggested method to load a MESS XML file doesn't work anymore. As soon as the changes are done to engine.cfg and clrmamepro is started again, clrmamepro will display an error while scanning the available datfiles.
The errormessage states "Found an incomplete datfile or a bad exe-output!" followed by information about the last set that is correctly imported.
At this point there has not been any datfile added and all sets were correct before the change.
Some more information that may be relevant:
- All datfiles in the profiler were either MESS softwarelists (XML) or MAME (XML).
- I'm running clrmamepro on Linux (64-bit) using Wine.
- I remember using this method successfully before with an older version of clrmamepro (I think until around version 3.134).
If you need more information let me know.
Thanks!