EMULAB Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

The new forum is online, hope you enjoy it!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Head

Pages: [1]
1
clrmame Discussion / Re: Problems with scanning and rebuilding
« on: 17 January 2011, 09:28 »
I tried both, newscan and scan - same effect.
Not network-paths, all on HD, Win7 64..

The folders are ok, other Dats works without any problems in the same Directory...
Maybe the dats are broken?

I'll send you the files that you want and also some Screenshots.

Thx
Head

edit: ok, problem #2 was a layer 8 failure ;)

2
clrmame Discussion / Problems with scanning and rebuilding
« on: 17 January 2011, 05:47 »
Hi..

I'm using Clrmamepro (3.137b now) quiet a while and i'm very happy with it.

But i'm a little bit confused at the moment:

1. Problem: If I rebuild with a tosec Dat a Set, it finds the whole set and the rebuilder does his job. A scan after the rebuilding says, that everything is fine.
But if I load the profile again and start a new scan, clrmamepro doesn't find any ROMs/Sets and all the rebuilded files are now "unneeded".
I can repeat this procedure with the same result.

2. Problem: If i want to rebuild from the Backup-Path, I use the Button to set the BackupPath as source. When I rebuild he doesn't find anything.
But when i select the same (!) path manually (with [...]), the scan runs successfully and every rom will be found.

So what's wrong?

Thank you

Head

edit: Problem solved!!! Thank you Roman for your great support!

Pages: [1]

Page created in 0.116 seconds with 21 queries.