EMULAB Forum

clrmamepro [English] => clrmame Discussion => Topic started by: adabo on 17 June 2017, 02:49

Title: How can I rebuild without removing from the source dir?
Post by: adabo on 17 June 2017, 02:49

When I rebuild to and older set using a new set, the source (new set) loses a bunch of sets. How can I prevent this?

I just want the rebuild process to leave the source directory unchanged. If that's even possible.

Title: Re: How can I rebuild without removing from the source dir?
Post by: adabo on 17 June 2017, 04:04

eh, I'm a bit slow. I think I figured it out, because apparently I was doing it all wrong before. This time I put the source folders in the Add Paths. Source folders unharmed :)

Title: Re: How can I rebuild without removing from the source dir?
Post by: Roman on 17 June 2017, 14:12

well, the defaul rebuilder option *is* to not remove any source files. There is an extra option for it to turn removal of rebuilt source files on.
The rebuilder takes files from the given source folder (or drag'n drop, or addpaths) and adds hash matched files to the destination (or system default paths).