EMULAB Forum

clrmamepro [English] => clrmame Discussion => Topic started by: jfromeo on 18 October 2009, 12:10

Title: [clrmamepro] Doesn't allow me to Split/Merge sets
Post by: jfromeo on 18 October 2009, 12:10

Hello to all the community.

I'm using clrmamepro 3.131 x64 and I'd like to merge a romset originally in Non-Merged set and compressed in .zip to a Split set in .7z compression. But either the merger nor the rebuilder tab give me the option to do this. In the rebuilder tab I simply can't choose the option Split sets, as I show in the image below, and in the Merger one, after selecting Split sets and .7z compression the button at the top down-right, (Un-)Merge, simply does nothing (I guess there should be a Merge button not an (Un-)Merge one).

(http://img197.imageshack.us/img197/3996/78096403.png)
(http://img25.imageshack.us/img25/416/49330250.png)

I'm using the last dat set for this romset and in Scan+Fix proccess it gives me 0 missing roms/sets.

?Is it not possible to merge Non-Merged sets into Split ones? ?Do I need anything else?

Any kind of help would be much appreciated.

Thanks in advance.

Title: Re: [clrmamepro] Doesn't allow me to Split/Merge sets
Post by: Roman on 18 October 2009, 18:54

The datfile defines if you can split/fully merge sets. If the datfile doesn't hold any parent/clone relationships (or even hold statements like forcemerge modes), you simply can't split merge sets. Since the merger is a very old part of cmpro which is nearly not used anymore (since you can do everything with scanner/rebuilder), I assume it shows an enabled split/fully merge radiobutton by mistake.

Look at the datfile (or send it to me), if it doesn't hold any parent/clonerelationships, the behaviour is absolutely correct.

Title: Re: [clrmamepro] Doesn't allow me to Split/Merge sets
Post by: jfromeo on 18 October 2009, 21:07

Oh, thank you so much Roman. You were right. I asked it because with other dats I could do merged/split rebuilts, but not with the No-Intro dats.